Yes when was redoing the inside figured I'd take the hole saw mount new gauges up on the upper part of the dash.In the process found out It was harder than I thought but not bad when nothing else is there.Last night fired up the cruiser after mounting the dual exhaust started oil shot everywhere, inside at the new gauges and right buy where it goes into the block come to find out water temp gauge shorted melted the tubing in a couple of places.So pulled the cd player out of the dash and ashtray and speedo cluster out of the way and it still took and couple of hours to get the bastards out.Anyway long story short I'm starting to see why know one mounts gauges in the steel dash (but it looks good)go home tonight mount the new ones in same location or cut out dash and put stainless in