Steering, u-joint grease (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 27, 2003
Threads
358
Messages
6,437
Location
Georgia Tech
Should I be putting Moly or standard grease in the u-joints and steering components? I though the only place moly is needed is the front axle knuckles, but apparently Mr. Haynes thinks otherwise. ???
 
I think the biggest concern would be the "lack of".............(?)
 
Ok, well let me rephrase-are there any places you SHOULD NOT put moly grease? If there aren't then why not just run moly grease in everything? It sounds like a better grease. I currently have two guns one for standard lithium and another for moly-lithium, and both are crappy and am looking to replace with a good pnuematic gun. Would like to only need to buy one pnuematic gun and not two.
 

Users who are viewing this thread

Back
Top Bottom