SOA today (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Gumby

Supamod
s-Moderator
Joined
Dec 13, 2002
Threads
337
Messages
12,557
Location
Knee deep in hookers and gin
I finally got the time to work on my own junk today. I chased down my wiring problems, (no power to the injectors during cranking) mounted the fuse boxes and took 'er for a drive. Still having fuel delivery problems so I built a surge tank with a higher pressure and higher volume pump. I will install it later this week with a adjustable fuel pressure regulator I'm making as described on thirdgen.org.

I was disappointed on the brief ride at the flex. the front end moves OK, but the back was way too stiff. i was climbing frozen snow piles left over from the plows and just couldn't get it to flex well. I decided the time was right to swap out the new Dar springs for a SOA. I took my old stockers and took out the bottom two leaves. I had the mopar spring perches left over from another job. Took about two hours to have everything bolted up. i still have to finish weld in the perches and fab up some shock mounts. I also need to build a anti-wrap bar.

The ride and the flex are 100% better. It sits damn near the same height, but moves way better. I'm going to have to make dropped bump stops, where before I couldn't get it to stuff anywhere near the wheel wells.

A good day. Thanks for the day without students, MLK Jr. :cheers:
 
Here you go:

worthless.gif
 

Users who are viewing this thread

Back
Top Bottom