Shims found ??

[merbesfield]

The leveling shim is installed between the spring and the axle spring perch. The shim is installed on the side that's higher, it is designed to lower the side that is higher by about an inch. I have a couple of them for sale in the classified parts section. I'm open to offers within reason.

My FJ is higher on the right side. Why does the parts manual refer to this leveling shim being placed on the left side? Also, what is John aka. peesalot, one post above you say that i have to use both the leveling shim and the angle correction plate together? I just had a new Tom Woods drive shaft and stuff installed to correct an incorrect differential angle after the OME kit was installed. I don't want to mess my nice driving rig up after everything I have gone through to get this thing driving nice.

 

[pb4ugo]

FAQ's

" Cruiser lean "

forum.ih8mud.com

 

[pb4ugo]

Look what I found

I removed that little black cage inside the glove box to make room for the ECM and found an envelope, hoping there was money, these were inside. The OEM warranty card Butch

www.pirate4x4.com

 

[BWhitey]

The leveling shim is installed between the spring and the axle spring perch. The shim is installed on the side that's higher, it is designed to lower the side that is higher by about an inch. I have a couple of them for sale in the classified parts section. I'm open to offers within reason.

Do you still happen to have any leveling shim for sale? Thanks!

 

[pb4ugo]

They were sold. I think ccot sells an aftermarket one, or you could make one.

 

[BWhitey]

They were sold. I think ccot sells an aftermarket one, or you could make one.

Thanks for the help.....CCOT still has them!