Scepter fuel can gaskets

[dcguillory]

So I have been dealing with leaky fuel cans for years and finally searched mud and found out my cans all came without the gaskets that go in the lids. I hopped on ebay and bought a couple packs of em but they don't seem right. They are loose in the lid so they will just fall out if I am not super careful how I open and close the can. What gives? Is there more then one "Scepter Military Fuel Can Gasket"?

 

[Rifleman]

Did you think about going direct to Scepter for those gaskets?
Replacement Parts - Scepter Military - Military

 

[NLXTACY]

Did you think about going direct to Scepter for those gaskets?
Replacement Parts - Scepter Military - Military

Specter doesn't sell fuel can parts to the US. It's frustrating as hell. But...
Scepter Military Fuel Can Viton Gasket

 

[TRAIL TAILOR]

Specter doesn't sell fuel can parts to the US. It's frustrating as hell. But...
Scepter Military Fuel Can Viton Gasket

Petr @VidereStudios probably has some on the shelf. He brings new cans back from Canada on a pretty regular basis.

J

 

[NLXTACY]

Petr @VidereStudios probably has some on the shelf. He brings new cans back from Canada on a pretty regular basis.

J

That's the way to go. Direct from Canada

 

[TRAIL TAILOR]

That's the way to go. Direct from Canada

I have to say his customer service with me has be exemplary as well. I've ordered a few times from him in the past 4 months.

J

 

[dcguillory]

Specter doesn't sell fuel can parts to the US. It's frustrating as hell. But...
Scepter Military Fuel Can Viton Gasket

That looks the same as what I have . . . Do you know the OD?

 

[jdayment]

It's hard to tell in the pics but do you still have the lip in the cap the center ring should have a lip on it raised about 1/2" that "holds" the gasket in place on the lid it's common for them to break off if you were using the original diesel gasket with gas. Gas causes the original gasket to shrink breaking the ring.

 

[dcguillory]

Definitely no lip inside any of the caps. hmm well i will send @VidereStudios a message. Thanks for the input guys.

 

[nukegoat]

Yep there is usually a cylinder on that cap part made from very thin material that retains the gasket. Very common to break them there and yours are broken.

 

[dcguillory]

Thanks for the help guys. Yea, need a new flange . . . . . 4 years later.