Remove centre console/armrest LC200 -08 (1 Viewer)

[Klasagasa]

Anyone know how to remove the armrest to get a hold of the handbrake assy?
I have the version with rear a/c (4-zone)
I have tried to find instructions on YT but no luck!
Anyone?

Regards, Klas

 

[lx200inAR]

Anyone know how to remove the armrest to get a hold of the handbrake assy?
I have the version with rear a/c (4-zone)
I have tried to find instructions on YT but no luck!
Anyone?

Regards, Klas

The hand brake assembly is under the cup holder. You can remove the cupholder by pulling it directly up towards the roof of the 200. It is only held in with clips. I don't think only removing the armrest would gain you any access better than pulling the cupholder. If you need to remove the entire console, that's more involved.

 

[Klasagasa]

The hand brake assembly is under the cup holder. You can remove the cupholder by pulling it directly up towards the roof of the 200. It is only held in with clips. I don't think only removing the armrest would gain you any access better than pulling the cupholder. If you need to remove the entire console, that's more involved.

That is what I am looking for! I am havibg a hard time reaching the assy underneath the console.

 

[lx200inAR]

Do you need to get further than this?

Thread 'LX 570 center console'
LX 570 center console - https://forum.ih8mud.com/threads/lx-570-center-console.1311884/

 

[Klasagasa]

Do you need to get further than this?

Thread 'LX 570 center console'
LX 570 center console - https://forum.ih8mud.com/threads/lx-570-center-console.1311884/

Yes, I would like to remove the console (cooler in some models) aswell! I am about to change the parking brake wires and find it difficult to work in that tight space.

 

[bloc]

If I remember correctly the rear face of the console pulls off, giving access to the screws that hold the console lid/armrest on. Then things get further disassembled from that open area.