I've got the starter apart to put new contacts and plunger in it. I'm wondering where to put grease to lube the plunger. It has a skinny section - almost a rod - with the spring around it, and the fatter section is my question. The fatter section runs in a bore and the one I'm removing is completely dry. The engineer in me says put a bit of lube on it. But the engineer in me also says it was dry so replace it dry.
What say ye??
If lube, what kind of grease? I've got everything in my shop.
On my other 80 a few years back I believe I put a light film of synthetic grease in there but I'd like to know if someone has better info. The FSM is silent.
Thanks,
DougM
What say ye??
If lube, what kind of grease? I've got everything in my shop.
On my other 80 a few years back I believe I put a light film of synthetic grease in there but I'd like to know if someone has better info. The FSM is silent.
Thanks,
DougM