may? have to. with the full time 4wd you dont want to run very far with that as a spare.
SO WHERE ARE THE PICTURES?!?!?!?!?!?
SO WHERE ARE THE PICTURES?!?!?!?!?!?
Real Time Help: Bumper install - Stuck bolts
- Thread starter sonk76
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Isn't his spare the same size as his other tires???
Negative. BFG specs his 275/70/18 TA/KOs at 33.2"
, I was thinking 16 inch rim
sleeoffroad
Supporting Vendor
I picked them up from the machine shop this week and will get one out to you today.
- Thread starter
- #26
Fantastic! Thanks Christo!
And thank you for all the great support all along the way!
And thank you for all the great support all along the way!
- Thread starter
- #27
Pictures as promised
Here are a couple of quick pics (no action shots yet...)
Here are a couple of quick pics (no action shots yet...)
truck looks awesome. Not many black ones built up on here.
That looks great. I am putting the arb on next week, and look forward to the slee back bumper once i save a bit. Is your lifted, or just in "Hi" mode
- Thread starter
- #30
It has a small "AHC" lift (i.e., 5 min adjustment of the height sensors) for about 1" lift, and it is then on the "Hi" mode.
are those only 275's? They look a bit bigger.
- Thread starter
- #32
Yup. They are 275/70R18's. As Loud pointed out above, they are a bit over 33" in diameter. Based on what I've been able to find, they seem to be just about the largest diameter tire one can put on these things without any rubbing while using the stock suspension setups, etc. I considered the 285/65R18, but those seem to be about 0.5" smaller in diameter.
I reasoned that for overcoming obstacles, the diameter of the tire would be the most relevant factor.
ooops, i was thinking 16 inch wheels. They look good. I have 295/75/16s on mine and they do great with the exeption of a little rubbing fully compressed and hard over. I am looking to replace the extremly durable
bang stock plastic skid plate on mine. If you dont mind me asking, how much did the part cost from slee. I am considering ahving a local shop do the fab.
bang stock plastic skid plate on mine. If you dont mind me asking, how much did the part cost from slee. I am considering ahving a local shop do the fab.
- Thread starter
- #34
ooops, i was thinking 16 inch wheels. They look good. I have 295/75/16s on mine and they do great with the exeption of a little rubbing fully compressed and hard over. I am looking to replace the extremly durable
Slee - Toyota - 100 Series Skid Plates
Man those look nice!!
