I just purchased an uncut transponder key for my 99 Land Cruiser ($21.00 as opposed to ~$50.00 from the dealer). The individual that I bought the key from recommended a reputable key cutter cut the key. When researching how to program the key I came up with the following information:
Add Duplicate Key
1. Simultaneously depress and release brake and accelerator pedals 1 time.
2. Insert existing master key into ignition.
3. Within 15 seconds depress and release accelerator pedal 5 times.
4. Within 20 seconds depress and release the brake pedal 6 times and remove key.
5. Within 10 seconds insert new key into ignition.
6. Within 10 seconds depress and release the accelerator pedal 1 time.
7. After 80 seconds new key is registered and security light goes off.
8. Remove new key and depress and release brake pedal 1 time.
Does anyone have any experience with programming a transducer key and if so, are these steps legit? Appreciate any insight/experience with this process.
Add Duplicate Key
1. Simultaneously depress and release brake and accelerator pedals 1 time.
2. Insert existing master key into ignition.
3. Within 15 seconds depress and release accelerator pedal 5 times.
4. Within 20 seconds depress and release the brake pedal 6 times and remove key.
5. Within 10 seconds insert new key into ignition.
6. Within 10 seconds depress and release the accelerator pedal 1 time.
7. After 80 seconds new key is registered and security light goes off.
8. Remove new key and depress and release brake pedal 1 time.
Does anyone have any experience with programming a transducer key and if so, are these steps legit? Appreciate any insight/experience with this process.