Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
So unless it’s crazy expensive, I’m in.Mine are hacked and the plastics are on their last legs. Did I miss the price?
Thanks.
Probably the perfect application.@Fast Eddy here is what I’m working with. I have almost no lip on the front and top, flares used to be attached above fender wells. What do you think?
View attachment 3346468
View attachment 3346469
Need to ask the vendor. It changes with the price of steel. Four sets fit in one sheet. That's why we need at least 3 to do it. I pay for the 4th set and I've never had a set sit around for long.Mine are hacked and the plastics are on their last legs. Did I miss the price?
Thanks.
Probably the perfect application.
Measure how far up from the lip to the flat top above the tire and from the lip to a line extended along the lower body line of the rocker. I'll measure mine later tonight.
@Fast Eddy thanks for doing this. We appreciate everything.From the lip up to the top of the fender well is about 1/2”, and from the lip above the tire down to the bottom of the rocker panel if measured vertically would be about 17”.
From the lip up to the top of the fender well is about 1/2”, and from the lip above the tire down to the bottom of the rocker panel if measured vertically would be about 17”.
Yea, you'll have to make a bend to go around the body crease at the front, or you could trim them along the body crease if you want.@Fast Eddy here is a photo of what we are working with. I'm not planning on moving the rear axle back, but from reading through the entire thread, it seems that these will work, but may need a little trimming on the front outer edge. Do you agree? Also, what are folks using to get a neat bend at the front contour?
Thanks.
Mark.
View attachment 3347469
Yea. I made the pattern from my previous rig which was uncut and original. The group would much appreciate your participation.So...for clarity...these mimic the stock wheel opening? My 40 has some wavy sheetmetal around the wheel opening and I'm thinking about these to use as a brace to help flatten that area but simply want the stock wheel opening. If so...I'm in for a pair.
FYI..the pic above has a broken link.
Yea, looks like @Will615 is out? We're on hold until, at least, I get my Porsche repaired and I see if I feel like funding two pairs myself. In the short-term I have to fund a very expensive new wheel. Maybe @USOffRoad will come to the rescue?Any updates to the group buy?
Thanks again!