PCV valve & Holley Sniper (1 Viewer)

[FJ Rock]

Does anyone know where/if the PCV valve connects to a Holley Sniper?

 

[BIG RENO AL]

My engine is a 76 and I used the inlet on the carb base with the Sniper and routed the hose there

 

[wngrog]

PCV should go into the side of the intake not the base of the sniper. You don’t want all that going into the base of the sniper if possible

 

[FJ Rock]

PCV should go into the side of the intake not the base of the sniper. You don’t want all that going into the base of the sniper if possible

@wngrog and @BIG RENO AL thank you for your help.

On the side of the block do we need to have a PCV valve and hose to pull vacuum on the crank case? Just wondering what plugs this hole.

Also where I have this filter on the valve cover, does this need to connect anywhere for a vacuum?

 

[wngrog]

The first pic. PCV valve. Run a hose around the firewall side of the motor into the center of the intake. There should be a provision there to put an elbow.

the valve cover just needs filtered air. That’s ugly but does the job