Out of mothballs (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 20, 2023
Threads
34
Messages
242
Location
Bogota
Six months since I drove it. Battery's dead, fuel evaporated. Any preflight suggestions ?

20240403_143001.jpg
 
Pull the plugs and give each jug a shot of Marvels mystery oil then whirl it over until it builds oil pressure.
 
Mine sits for months and months each year I just randomly crank it over whenever I get around to it. Mines been sitting for 13 months this time around and I’ll just crank it over till it fires up. I’m not to worried , Now that you asked this question I’ll have to find a way to fire mine up soon. Hopefully she fires. Hmm.
 
I use a big syringe with some tubing - less messy. 10cc or so if it has been a long time, 5 is enough for over winter. My 72 sat for perhaps 15 years out side. -20 to over 100. I dosed it up really good at day one. Then every few years when I had to move it like 10 yards to clean up around it and move it back using the starter I would give it a shot. Low range and no plugs makes it easier on the starter. Anyway this spring, I had to file the points to get spark, put on a new $10 electric fuel pump and she fired right up on fresh gas. Hardly smoked at all for a few minutes.
 
I use a big syringe with some tubing - less messy. 10cc or so if it has been a long time, 5 is enough for over winter. My 72 sat for perhaps 15 years out side. -20 to over 100. I dosed it up really good at day one. Then every few years when I had to move it like 10 yards to clean up around it and move it back using the starter I would give it a shot. Low range and no plugs makes it easier on the starter. Anyway this spring, I had to file the points to get spark, put on a new $10 electric fuel pump and she fired right up on fresh gas. Hardly smoked at all for a few minutes.
Gr8.
You got points huh..
 
Yes. The PO set up my rig with a Delco distributor and a Rochester 2 BBL. I added the header when the cast iron exhaust manifold cracked in half.
 

Users who are viewing this thread

Back
Top Bottom