New tool !!!! (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Poser

Oh...Durka Durka Durka.
Supporting Vendor
Joined
Oct 1, 2003
Threads
263
Messages
20,474
Location
MN
Got this yesterday, set it up today. Worth every penny, and then some!!!

I have used these at other places I have worked, and always wanted one. What a tool!

Should be able to cut just about anything now, between the plasma, the DoAll, and this one!





Ellis 1600
 
Last edited:
[tim-toolman]oh oh oh oh oh[/tim-toolman]

got me one of those too....simpler unit, but they rock!!
 
[quote author=UpNorth link=board=14;threadid=6135;start=msg49370#msg49370 date=1065752556]
Nice! You must have quite a workshop going.
[/quote]


There are a few people out here, that have been there...

Here are some pictures of stuff at the shop from earlier this summer...

Nothing too fancy...


http://www.mindcrater.com/Gallery_28Jun03/index.htm
 
Heeeeyyy I recognize that shop ;)
Good to "see" you Poser... :beer: :cheers:
 
Holy dead post --- 4 years?!?! I think this is a new record...
 
that is cool, I have an fmb miter head, only miters to right, and does not go vertical, I wiish I had kept my vertical!!

what was the cost of this?
 
I got the cheap HF metal bandsaw so I could test and see if I would use it much. Didn't want to drop too much money on something I ended up not utilizing.

I am still using it 2 years later but as soon as it breaks, I will be getting a quality version. The nice thing is you can do other things while the metal is cutting (or drink beer).
 

Users who are viewing this thread

Back
Top Bottom