New Hub Assembly --> flange nuts for outer shaft

[pavell]

Hey guys,

I'm ordering this hub assembly along with new rotors.

my question is the flange nuts that I've circled in yellow. will I be able to remove them from my old assembly. are they simply pounded out ? and re-installed in the new hub with a brass hammer ? Please advise.

https://partsouq.com/shop/product/9011610201-toyota-bolt-stud-for-front-axle-outer-shaft-flange-rh-lh/18049310

 

[3_puppies]

it's early, but I think those should be studs, that is what the drive plate mounts to

 

[badlander]

Correct, they are studs that are screwed in. You should be able to remove the old ones from the old hub by locking two nuts together on the studs and wrenching them loose with the wrench on the inner one.

 

[excessive]

or you could just buy new ones , they are avail from Toyota and relatively cheap

 

[offoradjunkie]

They are studs. Take two nuts against each other, and you can remove the studs. Here is the kit from @cruiseroutfit

 

[MongooseGA]

IIRC the studs are also end- specific. Meaning one half of threaded section is slightly longer than other end.

 

[2000UZJ]

Get new ones...please. If you are investing the time, get new hardware. It will be so much easier to install. I have trouble getting the nuts off the stud without buckling a thread or two. It's just one slip of the dead blow and the stud is damaged.

Hub/Drive Flange Stud Kit (PACK of 6) - OEM Toyota - Fits 01/1998-07/2007 100/LX470 & 105/Late 7x Series (10mm) Applications (HUB9807KOEMSET)

Hub/Drive Flange Stud Kit (PACK of 6) - OEM Toyota - Fits 01/1998-07/2007 100/LX470 & 105/Late 7x Series (10mm) Applications (HUB9807KOEMSET)

cruiserteq.com