So I decided to do the glow plugs on my BJ60 ( 3B 12V).
Replaced all 4 with NGK 7493
Cleaned all my contacts etc and no start.
Put in my old plugs with were denso 067100-1680 and it fires right up
Figured I just missed something and put the new plugs back in and it won't fire up at all.
I checked the resistance on all 8 plugs now and the only ones reading anything over 0.5 where 2 of my old ones, so i figure they are one the way out.
Anyone have any suggestions?
Its a bit hard to check voltage at each plug since by the time i have a good contact with my meter the plugs have cycled...
On a 12V 3B the glow plugs get 12V right?
Replaced all 4 with NGK 7493
Cleaned all my contacts etc and no start.
Put in my old plugs with were denso 067100-1680 and it fires right up
Figured I just missed something and put the new plugs back in and it won't fire up at all.
I checked the resistance on all 8 plugs now and the only ones reading anything over 0.5 where 2 of my old ones, so i figure they are one the way out.
Anyone have any suggestions?
Its a bit hard to check voltage at each plug since by the time i have a good contact with my meter the plugs have cycled...
On a 12V 3B the glow plugs get 12V right?