Too bad about the heated steering wheel not working, it’s one of the features I wish my GX had. Cool take on a build!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Thanks! Stock springs on the rear?Alignment no issue with stock UCAs.
Yes. The lines don’t perfectly match. The driver side of the rocker panel needs a little trimming to remove the clip holder - since the clip position isn’t right.I did the rocker panels swapped today but I couldn't make the front 2 clips go in and it didn’t line up with the fender. Did you run into that problem.
View attachment 3787721
View attachment 3787722
View attachment 3787723
Thanks for the reply! So you didn’t use the first clip and just tighten it up with the mud flaps? I have the mud flaps just haven’t put them on. I will try to do that tomorrow.Yes. The lines don’t perfectly match. The driver side of the rocker panel needs a little trimming to remove the clip holder - since the clip position isn’t right.
Also fits best with the prado front mud flaps. These tighten the whole front up.
You gonna trim the rear bumper too? If so can you share details and pics on what you did? I'm still a bit apprehensive about where and what to cut.I did the rocker panels swapped today but I couldn't make the front 2 clips go in and it didn’t line up with the fender. Did you run into that problem.
View attachment 3787721
View attachment 3787722
View attachment 3787723
Yes. Don’t use the clips. Remove the clip holder on the driver side by cutting it off (gives more space to have the panel fit snug). Then put on the mud flaps.Thanks for the reply! So you didn’t use the first clip and just tighten it up with the mud flaps? I have the mud flaps just haven’t put them on. I will try to do that tomorrow.
Thanks for the tip. I was able to get them in! The mud flap helps a lot.Yes. Don’t use the clips. Remove the clip holder on the driver side by cutting it off (gives more space to have the panel fit snug). Then put on the mud flaps.
don’t have plan to trim the bumper as I tow from time to time. Probably gonna add rock slider next.You gonna trim the rear bumper too? If so can you share details and pics on what you did? I'm still a bit apprehensive about where and what to cut.