I just added a swing away tire carrier and spare tire after years of not carrying a spare. It looks, to me, like my truck is sagging a little in the back now. I ordered some 30mm spacers for the rear springs from Dobinsons, is this a good way to go? Is there a good spot to measure front and back height, so I don’t just have to eyeball it?
Measuring ride height (2 Viewers)
- Thread starter cville80
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I think most people roughly measure from the center of the wheel hub, straight up to the wheel arch/fender
Mandrake
Supporting Vendor
Nothing wrong with using spacers to level it out, if that's what you're asking.
voodu3
SILVER Star
There are several ways to measure as mentioned above.
1. center of cap to the bottom of the flare is probably the most common.
2. The FSM has you measure through the coil spring
3. @Delta VS says to measure the difference between the pan hard bar mounts from the ground
Any of them will get you an idea of how much to add.
1. center of cap to the bottom of the flare is probably the most common.
2. The FSM has you measure through the coil spring
3. @Delta VS says to measure the difference between the pan hard bar mounts from the ground
Any of them will get you an idea of how much to add.
