Hello all,
So I just finished replacing several front end parts, inner and outer tie rods, lower ball joints, new UCAs and repacking bearings. I was just placed the wheels back on and set the truck back on the ground and the studs on my lower ball joints and contacting the inner wheel. Any reason this would be happening? Checked the fitment of LBJ and they are seated and c-clips went on without issue. I know the suspension geometry is off by a bit due to the new parts, but I feel like that wouldn't effect the spacing of the wheel and LBJ? Will include pics when I get back home.
Thanks.
So I just finished replacing several front end parts, inner and outer tie rods, lower ball joints, new UCAs and repacking bearings. I was just placed the wheels back on and set the truck back on the ground and the studs on my lower ball joints and contacting the inner wheel. Any reason this would be happening? Checked the fitment of LBJ and they are seated and c-clips went on without issue. I know the suspension geometry is off by a bit due to the new parts, but I feel like that wouldn't effect the spacing of the wheel and LBJ? Will include pics when I get back home.
Thanks.