So I am in the process of base-lining my first 100 series. As I am working around vehicle I have noticed something with the door handles, but not sure if this is normal or not. The part of the door handle that you pull on has a lot of play in them. They all open fine but if I hold the door handle I can move it up and down quite a bit more than I would think. Seems like there should maybe be rubber or something in the rear of each handle to hold it tighter. Just always heard about build quality in these and I do see it, but after 24 years things tend to deteriorate. Just checking if that's normal or if I need to replace something. The clear coat has failed on all of them and was going to paint them.. but if they are bad then no point. Are these serviceable? Want to get this as close to factory fresh as I can. Thank you!