It's been leaking a little for months, but I came out today to find a large puddle of brake fluid. It appears that I am missing parts to this that would actually make if function properly (see pic). Isn't there supposed to be an arm that attaches to the LSPV to allow for it to sense a load? Anyhow, I'm posting this to ask what the general consensus is on these devices? I've read a number of posts where they just remove it entirely and then I've read a number of posts where an aftermarket manual valve is installed (Summit, Willwood, etc...). I don't plan on really hauling any large loads and the brakes seemed to work fine before this failure. Would I even notice any difference if an aftermarket valve were installed? Thanks for any input.