landtank's Upper Rear Links
- Thread starter Delancy
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Joey, let me get an update from the machine shop and if he's ready for the bushings if you could send one I'll replace it when it come in.
NLXTACY
Wits' End
Unlike Chris, he's super anxious to get his truck out of the driveway and onto the asphalt. Me, I'm chill
Whats the part number? I can send it out. Or I can send out whatever you need. I have a complete set but all your arms come with them so I have some extra now
Don't even begin to worry about that crap. It's just the reality of things and I've come to expect it.
The last bushing came in and the arms are scheduled to be completed by weeks end. I'm expecting to have everything ready to ship by the end if next week.
NLXTACY
Wits' End
Actually I'm going to wait for other armchair engineers to weigh in before I install.
- Thread starter
- #90
Haha.
I honestly didn't mean to insinuate anything of the sort, considering.
Meant I'd start beating on them, soon.
Keep in mind, I appear to be the only person on planet earth that's bent an "unbendable" upper rear link on a Toyota.
I have, without a doubt, already "tested" LTs lowers, well past an OE failure point.
Not sure how I wound up in the situation, but did have an entire corner supported by the upper half of an LT lower, without much more than a gouge in the paint.
Of course, as the other LT (from Metaltech) had stated, I don't know how to wheel, anyway.
I honestly didn't mean to insinuate anything of the sort, considering.
Meant I'd start beating on them, soon.
Keep in mind, I appear to be the only person on planet earth that's bent an "unbendable" upper rear link on a Toyota.
I have, without a doubt, already "tested" LTs lowers, well past an OE failure point.
Not sure how I wound up in the situation, but did have an entire corner supported by the upper half of an LT lower, without much more than a gouge in the paint.
Of course, as the other LT (from Metaltech) had stated, I don't know how to wheel, anyway.
Sounds like you wheel using the Braille method, that can get dicey.
Josh should have them already and contacting everyone about shipping. Any time now.
NLXTACY
Wits' End
Stop worrying Chris. When I get mine I will let you know 
- Thread starter
- #97
Stop worrying Chris. When I get mine I will let you know
Ain't skeered.
Trying to motivate myself to finish her. Part of the process is chopping the rear frame rails, incorporating an aft mounted sway bar, and figuring out shock specs.
While I was there, be easy to swap links, so thinking ahead. They'll probably sit in garage until end of April, anyway, with rest of the pile.
Was super enthused about completing a few easy, minor to dos today, but spent the last two hours beating on the last Krawler, trying to complete the spare, only to take to tire shop and watch then do it in about 30 seconds for $5.
- Thread starter
- #100
Sorry Chris
A years worth of prodding to produce only to get second billing. Hahaha.
It may be a toss up to who gets them on first at the rate both of us move, anyway.
