front pic of the bumper. Notice the parking sensors are installed. This bumper tucks in a lot more than the 2010-2013 version of the classic.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I lost my headlight washers with my MetalTech front bumper.It looks great, but let's see a few more angles. I am guessing that with the classic bumper you lose your head light washers?
I do not have enough room for the headlight washers. I like how there is enough clearance for me to reach in and config the winch. Also, I added the 6 ohm resistors in parallel and now the blinkers are working at normal rate.
View attachment 2358404
View attachment 2358405
View attachment 2358406
Sorry I missed this. The side sensors work great. The front sensors works fine most of the time. Sometimes, it acts up as if there is something really close proximity to it. This was isolated to the left center sensor. Before I got it to work at all, I had to drill and bevel the metal on front a little more. It would be too sensory to the metal surrounding it in front. Leveling it with the step bit helps a lot.Are the proximity sensors working properly?
Also, can you tease us with a few side pic's also?
I will sometimes get the "BEEP-BEEP-BEEP" from the sensors in wet weather. If ti rains and I've been wheel'n, mud may slide down and cover the sensor, same for snow, I've had snow slide down and cover the sensor and when I slow down for a street light, stop sign, etc. it'll start going off like I'm about to bump something.Sorry I missed this. The side sensors work great. The front sensors works fine most of the time. Sometimes, it acts up as if there is something really close proximity to it. This was isolated to the left center sensor. Before I got it to work at all, I had to drill and bevel the metal on front a little more. It would be too sensory to the metal surrounding it in front. Leveling it with the step bit helps a lot.
I have water bead up in the passenger side center sensor from time to time but after a few minutes of driving and a few turns it slides out and is no longer an issue.
Ha-ha-ha!!! You don't know what dry is until you've lived in So. Cal.!!!jeez......I'd like to drive the GX in the rain.......
dry as a popcorn fart out here........
Ha-ha-ha!!! You don't know what dry is until you've lived in So. Cal.!!!
Just like the song by Albert Hammond, "It Never Rains In Southern California" (1973)
How did you attach the proximity sensors?front pic of the bumper. Notice the parking sensors are installed. This bumper tucks in a lot more than the 2010-2013 version of the classic.
View attachment 2357999
= no shopping cart dings, door dings and all the other maladies that happen in parking lots! Personal peeve...no parking stalls out here