Next up on my way through this truck is the valve cover gasket. It's puking oil all over so it needs to be done and I have a few other things I need to clean up when I'm in there or along there. I have the OEM gasket and plug gaskets, however I need a couple of other part numbers that i can't seem to find. When I remove the intake hose above the cover, the two clamps one by the MAF sensor and one by the Intake manifold need to be replaced and I can't find the part number for those specifically. I am also going to do the plug wires as one has cracked at the distributor cap. The plastic covers that cover the plug wires over on the valve cover need replaced or at a minimum, the bolts that attach it to the valve cover replaced as at least one is pretty stripped out. Once the plug wires are out, I will also replace the plugs. What is the preferred gap setting as rock auto lists 3 different gaps .032, .040 and .044.
Short story: Part numbers for the following -
OEM Air Intake tube clamps
OEM Plug wire covers over valve cover
recommended plug wires ( i have the Denso part number that I'm looking at)
preferred plugs - looking at the Denso ones, just unsure on the preferred gap setting
Thanks for the help
Ryan
Short story: Part numbers for the following -
OEM Air Intake tube clamps
OEM Plug wire covers over valve cover
recommended plug wires ( i have the Denso part number that I'm looking at)
preferred plugs - looking at the Denso ones, just unsure on the preferred gap setting
Thanks for the help
Ryan