Full float axle shaft lengths

[Doublehead]

Hi.
Does any one know how long those shafts are?
Land Cruiser 60 rear full float and Land Cruiser 80 full float.

Thanks!

 

[brian]

i did'nt measure mine when i had them out.

 

[Kynot62]

60 full float
long side 38 and an 1/8th
short side 24

This is the length from the mount surface of the flange to the end of the splines. If you needed to know the wheel mount surface to surface, it's the same as a semi float, right around 58inches

And no they are not compatible with an 80 if that is what you wanted to know. Doesn't the 80 have a centered diff?

Tony

 

[Doublehead]

Thanks

What I am thinking is if I can mix together some stock shafts (and tubes of course) and make a reasonably wide full floating axle with a centered diff!

 

[Kynot62]

Simplify your life and just buy a Dana 60...

Not what I want but it would make your life easier.

Tony

 

[Doublehead]

D60 is a heavy pig

 

[brian]

Doesn't the 80 have a centered diff?

Tony

no they do not, it's not as off set as the others but its not centered either.