Wanted FJ60 Manual (11 Viewers)

[71-CRUISER]

I have everything that you need to swap from collum to floor shift 3 speed.....

PM me

 

[cruiserjones]

I have a complete front heater (box) for inside the truck, doesn't include the fan, (which is separate and under the hoodl.) Should be able to do the emblems as well. Hit 40guy@prodigy.net in Texas.

 

[glcarrell]

consider yourself pm'd... thanks

 

[Landpimp]

cant you just use(swap) 24volt bulbs in a 12volt light? I know Hella makes most of thier bulbs in 24volt.

I am looking for a pair of 24V Off Road lights for my BJ42.

 

[cahilc]

bump

 

[treerootCO]

The manual choke assembly will bolt to a DGE.

It isn't listed in parts but you could probably call them up. I bought all my Weber parts from them and haven't had a problem. Worst case is 399.00 new for a DGMS.

http://www.carburetion.com/Weber/weber.htm

 

[FeO2pig]

Check e-bay under fj55. Someonr had a pair and I got the driver side. I think I saw the pasenger one there recently. There is a guy from New Hampshire parting out two pigs.
Hope that helps.
Mel

 

[orangefj45]

unless you're working with chip foose, i'd say that a "5 day full resto" is beyond impossible.

now getting a cruiser running in 5 days is more than possible.

 

[HI^C]

HEY DID YOU FIND ONE? still lookin here.

get a good deal?

 

[reece]

FJ60 custom bumpers

looking for some burly bumpers/ bull bar type stuff.

want the rear to have a swing-out tire carrier.

HELP!!!

 

[SW20FJ40]

I have a rear heater from an 80 fj40. Please let me know if interested.

678-895-8739

 

[too tall]

wtb 37x13.5x17

looking for a set of tires 5 to be exact. mtr's preffered but radial is the only important part.

 

[burnt03]

Toyota Chassis and Body manual (78 FJ40)

Looking for a cheap FSM for my '78 FJ40

Thanks!

 

[Mike Goodknight]

Column stuff

I would be inersted in your old colomn stuff and the old tranny hump. I also have what you need and would be willing to work a trade, I don't have the soft top though. Call me 970 270 3332.

 

[yoda-g3]

WANTED: Coilovers w/ 14-16" of travel

Helping a buddy of mine find parts for the tube fram set up he's doing on his '42 Willy's. He needs (4) Coilovers with 14-16" 's of travel. Used is fine.


Thanks!

 

[Mike Goodknight]

WTB FJ45 truck seats, seatbelts and gas tank.

Just like it says, hoping someone decides to upgrade and these parts are not needed anymore. Thanks everyone.

 

[82-SOA-60]

Dash Grab bar

Just a shot in the dark here. Would anyone have a dash grab bar off a fj62 they would want to part with?


Thanks

Matt

 

[yoda-g3]

Need Thrust Washers ASAP

I was hoping to install my new locker this weekend, but due to the welded nature of the spider gears, I need new thrust washers to pull this off. This is for the rear of a '70 fj40. The manual doesn't give any specs on sizes so I may need a couple options. I'd be willing to 2day this if posible.

 

[cruiserjones]

I've got one...hit 40guy@prodigy.net

 

[zbm290]

1978 Fj40

I rolled my Cruiser last month and I need a windshield frame and hood. I have found everything else. If you have parts please email me back. I need to fix it!

Thanks, ZBM290