FJ40 Upgrade: Offset Teraflex High Pinion D60, 14 Bolt Hybrid Rear Axle (2 Viewers)

[69LC]

@Rock40 I poured through this whole thread today and learned a lot! I'm eager to get back to working on my 69 LS project too.

I have a Dodge dually front d60 I picked up a while back I'm planning to lob the inner Cs off and stuff them into a Ford 9" for the front. I have some SolidAxle Ind 6 lug hubs I found on MP for it. The rear will be a 9" with 14b spindles and SA 6-lug hubs. Your thread gave me some inspiration to hobble away from the couch (back junk) and start taking measurements and making plans. Im kinda hoping to use toyota calipers on the axles just to keep some yota blood in them, kinda like what you did with the 4runner rotors.

(I'll have a low pinion D60 center available if anyone knows of anyone looking.)

 

[Rock40]

@Rock40 I poured through this whole thread today and learned a lot! I'm eager to get back to working on my 69 LS project too.

I have a Dodge dually front d60 I picked up a while back I'm planning to lob the inner Cs off and stuff them into a Ford 9" for the front. I have some SolidAxle Ind 6 lug hubs I found on MP for it. The rear will be a 9" with 14b spindles and SA 6-lug hubs. Your thread gave me some inspiration to hobble away from the couch (back junk) and start taking measurements and making plans. Im kinda hoping to use toyota calipers on the axles just to keep some yota blood in them, kinda like what you did with the 4runner rotors.

(I'll have a low pinion D60 center available if anyone knows of anyone looking.)

Nice, that sounds like it’ll be a solid setup