FJ40 Floor Pan In An FJ45?

[cruiserkreutz]

Since it looks like complete early replacement FJ45 floor pans are NLA, I am considering an early FJ40 replacement pan. Anyone know if this will work?What modifications should I expect to need to do? My '45 is a 1967.



This is the '40 pan I am considering;
Land Cruiser 40 Series Pre-1978 Complete Front Floor board

 

[jm599]

Started to do that but instead just used the metal from the seats of a couple FJ55s. Had similar pattern of parallel ridges that was close enough match for the flooring next to tunnel. Then used plain metal sheet for small patches along rockers. But I have plasma cutter and like welding. And I covered with monstaliner which semi hid the seams. Rubber mats will hide most too.
But... your idea will be better but will require some modifications under the seat. Do you have rust inside the large rear floor brace?

 

[cruiserkreutz]

No rust, but the freaking PO cut the hell out of it. That's a whole other problem