Wanted FJ40 Fire Wall Hand Throttle Bracket as seen below (1 Viewer)

[GA Architect]

Improvising. It works. I even have the PTO LHD pedal for linkage, but the ball for the linkage was sitting too close to the header.


View attachment 2660091

View attachment 2660092

View attachment 2660093

If I wanted the bracket, I'd approximately scale the part by tracing its image in a drafting program, then adjust on the truck, with a rough version that can be bent accordingly.

I skipped the bracket, because the arc that the pedal moves has a significant radius, and having the end moveable allows the very end of the cable sheath to not have to bind the inner cable so much against a fixed position that the bracket creates. I wonder if that is why the second cable in post #14 is so kinked?

I have the dimensions of the bracket, and even bent one. However, the metal I bent wasn't thick enough and I don't have a press to deal with thicker steel. I plan to try and weld a stiffener on it, but haven't messed with it yet.

 

[FJ40GURU]

This would not work for you?

 

[GA Architect]

This would not work for you?

View attachment 2660531

View attachment 2660532

The one below is what I need.

 

[GA Architect]

I'm still looking for this.....

 

[447xpro]

SOLD - SoCal: 40 series hand throttle brackets

Aftermarket cable with both factory brackets. $100 plus the ride. I have a factory cable available as well. $100 with the purchase of the brackets. Not available separately. Call or post to follow up; no PMs please.. www.marksoffroad.net

forum.ih8mud.com