<edit - the install is completed, here's the summary link
of course, you should definitely read on to see how it went!
>
I’m working on tracking down the parts for a factory sub tank. I’ve found US or shippable parts for *nearly* everything, excluding shipping the total is around $700. Shipping will vary on your source, but figure about $400. <edit updated total after the full BOM entered and sourced>
I am having trouble sourcing the filler pipe. It is the same as the stock pipe, but has a bung on it for the sub tank to fill from, and the vent side pipe allows plumb in for the sub tank vent.
the part number is probably
If you‘ve seen this or have a source let me know.
it is labeled 77201 in the attached photo
Factory sub tank - sourcing and fitment discussion
Canister Connector extension. I used Ethernet cable. I think it would be better to use stranded cable if you can source it. 7 conductors are required. There are two blue wires. Pin 9 is one, this is connected to a the engine bay fuse box 7.5a efi no. 2 fuse. So the blue wire that traces to that...
forum.ih8mud.com
of course, you should definitely read on to see how it went!
>
I’m working on tracking down the parts for a factory sub tank. I’ve found US or shippable parts for *nearly* everything, excluding shipping the total is around $700. Shipping will vary on your source, but figure about $400. <edit updated total after the full BOM entered and sourced>
I am having trouble sourcing the filler pipe. It is the same as the stock pipe, but has a bung on it for the sub tank to fill from, and the vent side pipe allows plumb in for the sub tank vent.
the part number is probably
77201-60B00
though there are many varieties that come up . . . B10 thru B90 . . .If you‘ve seen this or have a source let me know.
it is labeled 77201 in the attached photo
Last edited: