Existing Brake Controller connector

[Romer]

I bought a Tekonksha P2 and Toyota adapter cable. The instructions say there is a 5 pin connector taped to another cable that is open you plug the cable into. Anyone have any tips on where to locate it?

 

[OregonLC]

Interesting. I wonder where it terminates in the rear? IIRC the trailer harness doesn't have any spare pairs.

 

[hoser]

I'm going to help you out in hopes you'll give me a tour of your Kimberley Karavan one of these days.

Brake Controller connector for 2006 LC

 

[Romer]

I'm going to help you out in hopes you'll give me a tour of your Kimberley Karavan one of these days.

Brake Controller connector for 2006 LC

Anytime my friend. That thing is cool

 

[Romer]

Thanks Hoser, those are pretty straight forward. Even I could follow them. Not sure why it didn't come up in a search

Will need it to pull the Karavan when it gets here from Australia. The bottom picture is Brad from Arizona pulling the first Karavan in the US. I will have number 4

 

[Bear Lake Cruiser]

I don't want to ask but I will. How much is that trailer delivered to tucson phoenix area?

 

[arcteryx]

@Romer I just did this last week. Here is the post with a couple of pics to assist - Installing a Tekonsha 3040-P wiring harness in a 100

 

[Romer]

I don't want to ask but I will. How much is that trailer delivered to tucson phoenix area?

With the AUD the way it is, about $50K. It was $85K when the other two bought one. I didn't want to spend anywhere near that, but seemed like a once in a life time type deal, $35K off

@Romer I just did this last week. Here is the post with a couple of pics to assist - Installing a Tekonsha 3040-P wiring harness in a 100

Thanks!

 

[Bear Lake Cruiser]

With the AUD the way it is, about $50K. It was $85K when the other two bought one. I didn't want to spend anywhere near that, but seemed like a once in a life time type deal, $35K off



Thanks!

C'mon lotto!

 

[Romer]

Both sets of instructions were great and let me know exactly where the connector was. I didn't have to take anything apart. I felt around for it. Pulled it out far enough to verify. Mated it up and installed the cable. The install took me about 15 minutes.

I love this site

 

[Romer]

Been meaning to post this. The power wire in the harness had no juice. I could track it down or just run another wire to the Fuse. The fuse is in the engine bay, a 30AMP titled Towing Brake- It is what the EDW shows wired to the Brake controller cable. I drilled a small hole in the box and used one of these taps to tie into the fuse it was suppose to come from

I had to do some research because this is always hot and I was expecting switched power. The research showed it is suppose to be always hot and the Prodigy goes into sleep mode in a few minutes if no trailer is connected