Drivers side lower

[Etsha6]

I have noticed that the drivers side (RHD) of my '88 BJ74 is slightly lower than the other side. It is clear when you look at the 2 shakles on the front leaf springs that they are at slightly different angles.
Is there a simple bolt turning/tightening/torsion bar adjustment type solution to getting it level again?

Thanks
Ben

 

[lshobie]

It's just from the weight of the driver over the years, most of them do it. Easy fix is a new suspension There is no adjustment that can be made as the springs have lost thier "spring".

Regards

 

[crushers]

yo can get the springs re-arched but ihave had little luck in the re-arching lasting.
a belton kit is a sweet setup on a 74. you really should go a bit larger tires, 31 min and i prefer the 33 on the 74 wheelbase. it just looks right and the ride is greatly improved.
cheers

 

[Tapage]

I supose that more of the time you only drive your TLC ( more weight for hummm 18 years . ? in only one side ) you can put an add a leaf ( cheap ) in 4 corners or go with complete full suspension.

 

[Red Herring]

What about swapping spring sides? Temp fix??

 

[Etsha6]

Thanks for the feedback.

Long term solution is still a suspension upgrade and bigger wheels but in southern Africa low demand = high price.

I think I will try the left-right swap. Then, while I wear out the swapped springs, I should have a level truck for a few months!

 

[Tapage]

What about swapping spring sides? Temp fix??

one time when I get the stock springs do this magical solution .. hhhhuuuumm error .. ! need to go at alignment center inmediatly and, after some month get back to the original configuration.