Dissent Off-Road no cut rear modular bumper install videos (1 Viewer)

[LCT]

@samP504 Do we need to cut the lower pinch weld seam at the end of wheel arch (per Ben's instructions) or at the far end by the bumper (per your video)?

 

[samP504]

The bumper is tapered toward the back and so i cut back of the pinch weld toward the back but you make a keen and accurate observation and probably you are correct! However as you can see on the photos its not a huge deal to not cut it there. I guess at absolute full articulation (assuming it goes that far) it could grab that little corner of the pinch weld but I don’t think it would do anything. I will however make a note of it in the description of my video. Thanks !!

 

[LCT]

@samP504 Thanks for your response. Looks like you could still trim it with the bumper installed if it ever becomes an issue down the road.

 

[Joe422]

Nice... Just started "dry" assembling the accessory try and tire carrier... Vids helped~
Thanks Sam!