For Sale Disc brake backing plates 40/60 [FL]

[cruisermatt]

Vehicle Model

1. 40 Series

Have three sets available. All from 60's with the riveted junction block but will work just fine on 40's as well (with a 60 hose) Two are zero rust/damage that would be perfect to blast/paint for a resto. One of the third pair is nice and the other has some damage from the axle being set down on it. (Pictured bottom left)

$200 each + shipping (probably $35-40 /pair) for each of the nicer pairs, $150 +shipping for the less nice pair

Will make a nice package deal on new OEM hard and soft lines to go with them.

 

[cruisermatt]

 

[cruisermatt]

Bump

 

[cruisermatt]

Bump. Price drop $150+ shipping per pair on the nicer ones and $100 + shipping for the lesser.

 

[Engineer8000]

I will take a pair of the nice ones.

 

[cruisermatt]

Bump. Still have the other two pairs, plus I found this third set from a FJ62 (which have the big air ducts) that are in absolutely perfect shape. One still has the pink assembly line paint on it.

$300 plus shipping for this pair

Sold to @Green Bean

 

[cruisermatt]

Bump

 

[cruisermatt]

bump.. I still have a few more sets of these.

 

[cruisermatt]

Bump.

Also have a nice 93-97 80 series pair for $50

 

[Green Bean]

Good day, Matt. If, by chance, you still have available one of the pairs of backing plates that are in good condition, I will take them assuming they will fit on our 1970 40 series with a 1977 front axle with disc brakes. I would also like to purchase through you the hoses, and any suitable gaskets, and/or hardware involved in removing our old backing plates and replacing with yours. Note: I did a complete knuckle job about 1 year ago, and installed new calipers, rotors, pads, inner/outer bearings, etc. so I assume that all is good there, but not sure if I should get new hub locking washers, hub flange gaskets or anything else. Just email me an invoice and I'll send the $.
Thanks again!
Mark.

 

[cruisermatt]

Good day, Matt. If, by chance, you still have available one of the pairs of backing plates that are in good condition, I will take them assuming they will fit on our 1970 40 series with a 1977 front axle with disc brakes. I would also like to purchase through you the hoses, and any suitable gaskets, and/or hardware involved in removing our old backing plates and replacing with yours. Note: I did a complete knuckle job about 1 year ago, and installed new calipers, rotors, pads, inner/outer bearings, etc. so I assume that all is good there, but not sure if I should get new hub locking washers, hub flange gaskets or anything else. Just email me an invoice and I'll send the $.
Thanks again!
Mark.

Hey Mark, I should definitely have a few sets of nice ones. We also have the matching 60 series hoses and hard lines you would need in stock as well. I'll get a ticket written up and sent over to you. Thanks!

 

[cruisermatt]

Bump. Have 2-3 pairs of nice condition ones.

 

[cruisermatt]

Bump.
Have nice 76-79 set and several nice +80 sets

 

[cruisermatt]

76-79 set sold.