EDITED 7/24/17. I AM MOVING SOON. SHOOT ME AN OFFER.
I recently purchased a 40 series setup for rock crawling. I purchased it for some of the parts and I am selling the rest. Anything that doesn't sell I'll keep as spares or add into my build. All of these parts are fully functioning. Shipping is included where stated in the prices below.
PRICES ARE OBO. Thanks!
5.0 V8 EFI from a 93 T-bird (factory rebuild unknown miles) with complete running wiring harness and computer $1000 shipped
-NP435 $350 shipped
-AA adapter from NP435 to Orion. I believe it should also allow a stock tcase to mate up to it. $150 shipped
-Ft Axle components:
-3.70 R&P w/Aussie Locker SOLD
-6 Stud Knuckles w/ all new OEM studs
4x4 Labs High Steer w/ 1 ton TREs. Including drag link and tie rod SOLD
-Saginaw PS with PSC steering box. Including steering column and steering shaft $250 SOLD
-Rear axle: SOLD
14 bolt FF narrowed to run 2 short side shafts. Hubs turned and modified to 6x5.5
Chevy disk breaks. spare FF shaft
-Rear track bar $120 shipped
-I have a set of 36" Super Swampers with a small amount of tread left. $200
-Metal Tech roll cage and seat cradle. It's not a full family cage but it could easily be made into one. It has some damage from a roll on the back driver side. Could use a support replaced. This also includes a Metal Tech front grill/bib surround that is tied into the cage via side supports.
Unless the front a pillar is modified I believe this would need to go to someone who is planning to either run permanently without doors or with soft doors only. Asking $500 plus shipping
-(2) Procar seats $100
-15 gal fuel cell with efi fuel pump $100
-Bent front 8274 winch bumper $100 shipped
-Full spline front drive shaft SOLD
-4 point seatbelt $50 shipped
I recently purchased a 40 series setup for rock crawling. I purchased it for some of the parts and I am selling the rest. Anything that doesn't sell I'll keep as spares or add into my build. All of these parts are fully functioning. Shipping is included where stated in the prices below.
PRICES ARE OBO. Thanks!
5.0 V8 EFI from a 93 T-bird (factory rebuild unknown miles) with complete running wiring harness and computer $1000 shipped
-NP435 $350 shipped
-AA adapter from NP435 to Orion. I believe it should also allow a stock tcase to mate up to it. $150 shipped
-Ft Axle components:
-3.70 R&P w/Aussie Locker SOLD
-6 Stud Knuckles w/ all new OEM studs
4x4 Labs High Steer w/ 1 ton TREs. Including drag link and tie rod SOLD
-Saginaw PS with PSC steering box. Including steering column and steering shaft $250 SOLD
-Rear axle: SOLD
14 bolt FF narrowed to run 2 short side shafts. Hubs turned and modified to 6x5.5
Chevy disk breaks. spare FF shaft
-Rear track bar $120 shipped
-I have a set of 36" Super Swampers with a small amount of tread left. $200
-Metal Tech roll cage and seat cradle. It's not a full family cage but it could easily be made into one. It has some damage from a roll on the back driver side. Could use a support replaced. This also includes a Metal Tech front grill/bib surround that is tied into the cage via side supports.
Unless the front a pillar is modified I believe this would need to go to someone who is planning to either run permanently without doors or with soft doors only. Asking $500 plus shipping
-(2) Procar seats $100
-15 gal fuel cell with efi fuel pump $100
-Bent front 8274 winch bumper $100 shipped
-Full spline front drive shaft SOLD
-4 point seatbelt $50 shipped
Last edited:
