- Joined
- Nov 22, 2010
- Threads
- 44
- Messages
- 2,126
- Location
- Wilmington, NC
- Website
- www.kindredspiritscsg.com
Hello there, I need to repair my crankshaft pulley due to some wear on it.
I was wondering if anyone who might have one laying around could grab some dimensions off of the keyed shaft area so I could weld mine up and then turn it down again. What I am interested in is the OD of the shaft, also a side shot of the pulley would be a lot of help too.
Thanks in advance.
Stevo
I was wondering if anyone who might have one laying around could grab some dimensions off of the keyed shaft area so I could weld mine up and then turn it down again. What I am interested in is the OD of the shaft, also a side shot of the pulley would be a lot of help too.
Thanks in advance.
Stevo