Hi all, well I finally got around to getting a floor jack and some jack stands so I could take off the driver side front wheel to access the dreaded 52-55 error code sensors. Even with that it is not easy to reach.
The connector on my truck looks to be in good shape and I don't want to force it or break the connector taking it off to replace the sensor, but I can't seem to figure out how to safely remove the connector.
This is a new sensor plugged into a spare harness which I bought in case the connector on the truck's wiring harness got damaged. But how do remove it? I tried shoving a screwdriver of a couple of different sizes in the slot and nothing seemed to happen, and I can't seem to squeeze it hard enough to make it do anything. I'm sure it is obvious but can someone tell me how to remove the connector off the sensor safely?
The connector on my truck looks to be in good shape and I don't want to force it or break the connector taking it off to replace the sensor, but I can't seem to figure out how to safely remove the connector.
This is a new sensor plugged into a spare harness which I bought in case the connector on the truck's wiring harness got damaged. But how do remove it? I tried shoving a screwdriver of a couple of different sizes in the slot and nothing seemed to happen, and I can't seem to squeeze it hard enough to make it do anything. I'm sure it is obvious but can someone tell me how to remove the connector off the sensor safely?