Confirmation on Tire / Wheel Purchase... looking for a thumbs up from LC pro's before I buy

[prwillard2]

Welp. Are the TRD BBS Forged discontinued? I think they are dumping anything 5 lug.
Parts guy up north told me they are gone earlier when i was picking up body clips.

Did yall know? Am i just late to the party?

May be out of stock. Don't think they'll dump them as the Tundra uses them as well.

 

[AnyMal]

May be out of stock. Don't think they'll dump them as the Tundra uses them as well.

New tundra is six lug

 

[UPR LC]

Thanks anyone know offhand of where this is.... I’ll start searching

I removed the two screws (and plastic flap) that hold that small plastic "flap" to the wheel well liner. Then I used a heat gun (strong hair dryer) to heat the wheel well liner up, then I used the handle of a hammer to push the liner forward until it cooled. This "shapes" the plastic of the wheel well liner and stays out of the way of the tire. No rubbing. Quick and easy.

 

[grinchy]

Thanks anyone know offhand of where this is.... I’ll start searching

Fixed the broken link. sorry about that

 

[Jbriones]

I removed the two screws (and plastic flap) that hold that small plastic "flap" to the wheel well liner. Then I used a heat gun (strong hair dryer) to heat the wheel well liner up, then I used the handle of a hammer to push the liner forward until it cooled. This "shapes" the plastic of the wheel well liner and stays out of the way of the tire. No rubbing. Quick and easy.

Thanks for this .... didn’t even need the heat gun- followed a couple other pieces of advice and just pushed the plastic back about an inch or so and drilled new holes. Also removed the flap. Have about 1inch clearance now ...