daughterofromer is looking to get back into a rig. She liked the 3rd gen 4runner because it wasn't as wide as a 80 or 100 series. After riding in Dan's GX470, I thought that might be a good fit for her. Some research first
I carry lots of spare parts for my 100 series. My daughter Sarah also has a 100 series so she is covered when with me.
Obviously the CV axles are different lengths as the trucks are different widths. Is the OEM Reboot kit compatible with either?
Brakes Pads the same or different
I carry spare coil packs, I am guessing these are the same?
I carry a spare rear drive shaft, would it work?
Anyone looked at what parts are the same between the two series?
Next topic - Looks like I can get an ARB Bull bar from Iron Man, does ARB have one that fits (4runner)? Only like the bull bars on my rigs after experiences with deer and stupid drivers
Sliders need to be custom built or modified from the 4 runner. I'd like to be able to call up a shop and just tell them I want a set of sliders and they will show up on my doorstep
Can I do something similar with the Rear bumper and tire carrier?
I think I saw I can get skid plates off the shelf
She has the AHC. Our thought was to run that for a while until she can save up and then get a lift, what did others do?
Probably more later, we haven't decided on this platform yet, and wont be getting anything for a few months.
Anyone want to trade their GX470 for 2011 Scion TC?
I carry lots of spare parts for my 100 series. My daughter Sarah also has a 100 series so she is covered when with me.
Obviously the CV axles are different lengths as the trucks are different widths. Is the OEM Reboot kit compatible with either?
Brakes Pads the same or different
I carry spare coil packs, I am guessing these are the same?
I carry a spare rear drive shaft, would it work?
Anyone looked at what parts are the same between the two series?
Next topic - Looks like I can get an ARB Bull bar from Iron Man, does ARB have one that fits (4runner)? Only like the bull bars on my rigs after experiences with deer and stupid drivers
Sliders need to be custom built or modified from the 4 runner. I'd like to be able to call up a shop and just tell them I want a set of sliders and they will show up on my doorstep
Can I do something similar with the Rear bumper and tire carrier?
I think I saw I can get skid plates off the shelf
She has the AHC. Our thought was to run that for a while until she can save up and then get a lift, what did others do?
Probably more later, we haven't decided on this platform yet, and wont be getting anything for a few months.
Anyone want to trade their GX470 for 2011 Scion TC?
