- Thread starter
- #901
Finally off-loaded the Gecko today! Let the repairs begin.
PS pump
Alternator
Front leaves, or at least the shackle-side bushings replaced
Convince Yukon to make me a competition Zip Locker for my Toyota 8" like they do for the Dana 60
Cut out bed floor and redesign to lower CG
Replace t-case rear output seal
Install new RCV
Replace rear axle housing diff "cover" with 8" pipe cap and 2" fill port
Build trans tunnel
Add forced ventilation to underbelly
Fit air shocks to add some lift to clear the LTB's
There's a laundry list like this for the semi too, but I'll spare you all the reading.
PS pump
Alternator
Front leaves, or at least the shackle-side bushings replaced
Convince Yukon to make me a competition Zip Locker for my Toyota 8" like they do for the Dana 60
Cut out bed floor and redesign to lower CG
Replace t-case rear output seal
Install new RCV
Replace rear axle housing diff "cover" with 8" pipe cap and 2" fill port
Build trans tunnel
Add forced ventilation to underbelly
Fit air shocks to add some lift to clear the LTB's
There's a laundry list like this for the semi too, but I'll spare you all the reading.