Hey fellas,
Got a 2003 hzj79
When my Ute is out of gear the clutch isn’t disengaging fully I can’t get any gear when the car is at a standstill running, if I put it in gear before turning it on the clutch is working but the car will creep forward a little bit but it won’t stall if I put my foot on the brake and my motor isn’t loaded up or anything . my pedal has good travel before the clutch engages back on just doesn’t make sense
I have put a brand new genuine gearbox in, new genuine slave cylinder, new master cylinder, new clutch fork and release bearing came with box. Fella I bought it off had put a new clutch in apparently and it looked new, spigot bearing isn’t seized, it does have a little rattle in the bell housing but when you disengage the clutch it goes away, all of this was happening before the new gearbox as well. I have bought a new clutch and flywheel which are the last 2 things I haven’t replaced.
Just seeing if anyone else has had this problem or what else I could be missing. Thanks
Got a 2003 hzj79
When my Ute is out of gear the clutch isn’t disengaging fully I can’t get any gear when the car is at a standstill running, if I put it in gear before turning it on the clutch is working but the car will creep forward a little bit but it won’t stall if I put my foot on the brake and my motor isn’t loaded up or anything . my pedal has good travel before the clutch engages back on just doesn’t make sense
I have put a brand new genuine gearbox in, new genuine slave cylinder, new master cylinder, new clutch fork and release bearing came with box. Fella I bought it off had put a new clutch in apparently and it looked new, spigot bearing isn’t seized, it does have a little rattle in the bell housing but when you disengage the clutch it goes away, all of this was happening before the new gearbox as well. I have bought a new clutch and flywheel which are the last 2 things I haven’t replaced.
Just seeing if anyone else has had this problem or what else I could be missing. Thanks
