Clock cover? Switch panel? What's this space called? (1 Viewer)

[BigJoeSea]

I suspect I'm not searching the right words, but I'm looking for a pre-made, probably 3D printed panel that fits in the clock location of our FJ70s (and likely other models too). I got an aftermarket TPMS that should snap into a factory 'switch hole' for Toyotas/Nissans, and in the future I'd also like to put an ARB air compressor switch in too. I circled the clock in red below, but mine is just a blank panel.

Does anyone know if what I'm looking for exists in the wild?

This is the TPMS I installed

https://www.amazon.com/dp/B071Z8BT46/ref=sspa_dk_detail_right_aax_0?sp_csd=d2lkZ2V0TmFtZT1zcF9kZXRhaWxfcmlnaHRfc2hhcmVk&th=1

Thanks in advance!

 

[OGBeno]

Available from Toyota: 55533-90A00

 

[BigJoeSea]

Thanks OGB. I was hoping for an aftermarket solution with button holes ready for switches.

I definitely wasn't clear in my post.

If I were to cut the original, I'm not sure how id do so cleanly

 

[OGBeno]

Thanks OGB. I was hoping for an aftermarket solution with button holes ready for switches.

I definitely wasn't clear in my post.

If I were to cut the original, I'm not sure how id do so cleanly

Easy with a dremel implement.

 

[jblueridge]

Did you check the 3d offerings on THINGIVERSE?
I'm sure there are similar repositories of 3d files.

Probably easiest to use a dremel tool as Beno suggested.

 

[mattressking]

The shape is not for any blank in your specific truck. The ‘blank’ they refer to is to the left of your clock or below the HVAC.

Short answer, no. Late model vehicles sure/yes, just depends on the brand and location. The shape is not universal and is year dependent.