CLCC Swap Meet Wish List (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

4"
 
HJ45 Jim asked me to look for a pair of horns, he also needs the clutch pedal return spring and hardware that attaches the spring and pedal. Could also use the hard line for the clutch master. 78 ish FJ40 should work so prolly 74 to 78? Maybe a bit older and newer? His truck is a 78 HJ45 imported from Nicaragua
 
HJ45 Jim asked me to look for a pair of horns, he also needs the clutch pedal return spring and hardware that attaches the spring and pedal. Could also use the hard line for the clutch master. 78 ish FJ40 should work so prolly 74 to 78? Maybe a bit older and newer? His truck is a 78 HJ45 imported from Nicaragua

I have 1 horn.
 
I think I have some horns in my pile of crap vintage Land Cruiser parts.
 
I need a bolt for my father's Fairey overdrive. Does anyone a have an M8x1.25 100mm bolt in their magic bucket?
Will this work?
20160923_223210.webp
 
I was thinking it might be helpful to post-up a list of any parts, accessories, tools, etc. that you are looking for in case one of your fellow Mudders has one to sell or trade, but might not otherwise think to bring it to the swap meet.

I'll start with the following:

2F oil dipstick
1F round rubber engine mount
1F carb insulator

Did you find the 2F dipstick? I have a free one available for pickup in old town Alexandria. Or if no hurry I hope to get back to club meetings soon. Work has been busy and apparently babies take a lot of time. Who knew.
 
I'm looking for a rear bench seat for the 40. Something I can strap a car seat to. Just for local roads. On that topic I'm looking for front seats too, but lower priorty.

If not I may go with the one from IPOR. Seats
 

Users who are viewing this thread

Back
Top Bottom