Ok. I finally got the itch and pulled the motor and trans/transer for a rebuild.. the head is off to the machine shop, and I want to replace the cam.. I did a search on RV grinds and aftermarket stuff, but came up w/ little info.. what do you guys think about aftermarket cams, and when you install them do you need new springs, lifters etc..? thanks in advance. BTW, if it helps. I was running a 6-1 header, non-usa dist, and a rochester carb before removal. I will probably be going weber 38/38 or non-usa aisin for a carb. Im looking for best "bang for the buck".
Mike
Mike