I'm planning on rebuilding the knuckles since the right knuckle needs replaced and I was wondering what else I need to get along with the knuckle itself. I am getting a Marlin Crawler knuckle rebuild kit, new wheel bearings and a seal kit. Do I need to get new shims since the knuckle is out of commission? Will I have to properly seat it since it wont be the old knuckle seating into the old shims? I am very new to all of this and got this vehicle to learn. If one knuckle is busted is it worth it to get a new one for the other side? The other side(left side) looks fine. Would it be worth it to go all the way and get new bolts and what not as well
I have read other posts on the knuckle job and have been doing my youboob info gathering as well. I just didn't check close enough to see that the knuckle is toast before ordering everything else
Thanks,
Bagel
I have read other posts on the knuckle job and have been doing my youboob info gathering as well. I just didn't check close enough to see that the knuckle is toast before ordering everything else
Thanks,
Bagel