Wifey got home at 6:30 p.m its 9:30 now. Got the Cruiser jacked up and on stands. Started tearing in......not done by a long shot but here's where I'm at.
Have both birfs. out and soaking in my parts washer. Both hubs cleaned, new races installed, and new rotors put on. All parts (everything) cleaned and laid out on my bench for reassembly. Painted drive flanges,dust shields and caps.
Will drop the knuckles in the morning and start from there. Heck these things "tear down" easy. Its just alot of cleaning.
Looks like the wheel bearings had been repacked on mine at some time, unless
Toyota uses a red grease to pack them and a chisel to tighten the lock nuts.
Had gobs of grease in the birfs, and the rotors I took off were a little over 30mm. Brake pads were good...but its getting all new stuff anyway.
Can't believe someone used a chisel to tighten the locking nuts.....what a nitwit!
Have both birfs. out and soaking in my parts washer. Both hubs cleaned, new races installed, and new rotors put on. All parts (everything) cleaned and laid out on my bench for reassembly. Painted drive flanges,dust shields and caps.
Will drop the knuckles in the morning and start from there. Heck these things "tear down" easy. Its just alot of cleaning.
Looks like the wheel bearings had been repacked on mine at some time, unless
Toyota uses a red grease to pack them and a chisel to tighten the lock nuts.
Had gobs of grease in the birfs, and the rotors I took off were a little over 30mm. Brake pads were good...but its getting all new stuff anyway.
Can't believe someone used a chisel to tighten the locking nuts.....what a nitwit!