I just purchased my sliders yesterday and extremely satisfied with his workmanship. I finished painting em today and ready to put em on my rig. BTW, this also included a bolt on heavy duty cat protector which isnt in my photo shot.
Bink's Fabrication-Modesto, CA 80 series Sliders
- Thread starter sideways86
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #3
Definitely beefy and solid! Here's the bolt on cat protector. This makes life easy just in case u have to replace a cat.
- Thread starter
- #6
I told her that I bought it from u and I'm just painting it.
Thanks again for the business! Im glad you are satisfied with our product and hope to see you out on the trail. Keep me posted on how you like them.
These are a production piece and we will be stocking them for interested parties. The price is $700.00 plus shipping unless you can pick them up. We weighed them and they are about 80lbs a side.
Lower box is .250 wall and the outer 1.75" DOM tube is sleeved to .250 wall also. Attatchment riggers are all .190 and the skid is also .250. These are pure beef
These are a production piece and we will be stocking them for interested parties. The price is $700.00 plus shipping unless you can pick them up. We weighed them and they are about 80lbs a side.
Lower box is .250 wall and the outer 1.75" DOM tube is sleeved to .250 wall also. Attatchment riggers are all .190 and the skid is also .250. These are pure beef
Sweet mutherofgawd those look beefy! Those things could deflect an IED blast. Nice work.
that cat skid needs some bracing. I've seen a few sliders with this type of cat protection and they bend all over the place. Some bracing tying it to the frame or main slider rail is going to be needed for it to do it's job.
U realize thats pressbroke .250" with about 2" of plate in the vertical(diaganol plane)? If u have pics of that material thickness,pressbroke and fully welded out and actually bent and twisted "all over the place" i say post up. Otherwise i call a huge level of bull****.
Nice work
Those look beefy
Who needs cat protection
Those look beefy
Who needs cat protection
I agree with the above post. ^^^
BinksFab - Good luck with your new business, nice work
Last edited:
How about some pics of them on the rig and then maybe some on the trail shots!
Also does this forum have a vendors sale section? I'd like to spread the word more widely about these products. All of you 80 series guys deserve quality products like we are producing
I think what Landtank may be refering to is not the cat protector material being bent and twisted, you have obviously built a super tough protector, but the cat protector as a whole being bent and twisted due to how it is mounted in the middle of itself without any other bracing. I'm not too sure, but having it only bolted on in the middle of the protector does make me wonder about what would happen if it took a hit to the front or rear lip of it. Perhaps having it only bolted in the middle of the protector would act as a pivot point and cause it to "twist" at that point...does that make sense?
Beautiful sliders BTW! I love your guy's work!
Says the guy who's "sliders" bolt to the rocker panel...
So are agreeing or disagreeing with Binks Fab quality?
As for sliders I have only had slider on my 1st 80 and they were definitly not bolted to the rocker panel. For me sliders are not needed, I now use rock rails.
Last edited: