Anyone have any idea of specs on these rod ends? (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 11, 2002
Threads
155
Messages
1,759
Location
Elkhart, Indiana
Does anyone have any idea what the strength might be on these "rod ends" I'm thinking about using them for control arm ends that might be quieter/ softer than rod ends. I already contacted Speedway and they can't tell me anything other than they are not made in the US.


http://www.speedwaymotors.com/pl/90...,107,1534_Steel-Rod-Ends-and-Heim-Joints.html
910-02090_T.jpg
910-02088_R.jpg
 
http://www.mcmaster.com/

type in "heim joint" on the left side and go wild

I know where to buy high quality spherical bearing rod ends- that isn't the question. These interest me because you get the adjustability of the threaded stud in both left and right hand threads for tweaking the length of a panhard or control arm- I just have to wonder what the strength really is. I might buy one or two and do a little destructive testing just to find out.
 

Users who are viewing this thread

Back
Top Bottom