Forgive my ignorance, but can anyone point out where the valve covers are? I know...I know...
Thanks
Thanks
Anyone adjust 2UZ valve gaps? (2 Viewers)
- Thread starter Jim_Chow
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Awesome thanks. Off the top of anyone's head, what size socket is required for said tightening?#4
10mm
Will the tool to change get out the shims that makes pulling the cams unnecessary on other shim and bucket style Toyota engines not work on the 100?
Strike that. Just looked at the FSM and the shim is under the bucket on the 4.7.
Thanks Paul!
The FSM shows it under, but the parts diagram above shows it on top. I'm intrigued, I'd like to replace one of my shims. Does this look like it's on top?
Looks like the bucket is on top.
I was afraid you were going to say that.
Here are my numbers all in mm.
Intake 0.15-0.25mm
Exhaust 0.25-0.35mm
I had no real reason to check other than a valve cover gasket leak engine runs and sounds fine. Next timing belt ill check on them, a couple sat right at the upper limit.
Edit: maybe upper limit wasn't the best choice of words, 2 exhaust valves are at the loose limit and 4 intake valves are near the tight limit. Next timing belt should I be aiming for the middle of the specs?
Intake 0.15-0.25mm
Exhaust 0.25-0.35mm
I had no real reason to check other than a valve cover gasket leak engine runs and sounds fine. Next timing belt ill check on them, a couple sat right at the upper limit.
Edit: maybe upper limit wasn't the best choice of words, 2 exhaust valves are at the loose limit and 4 intake valves are near the tight limit. Next timing belt should I be aiming for the middle of the specs?
Last edited:
