JustJay
SILVER Star
Looking for advice on how to bend this floorboard back up to trans hump cover. Re-assembling after paint and now am noticing that somewhere along the way the floorboard end got compressed and now I've got a couple of places where there is a big gap between floor and hump cover. PO originally had a bunch of caulk around the hump and I figured it was just a poor sealing job. I should've test fit it after blasting old paint off but lessen learned. Can't really easily access it now from underneath. Kinda feels like I'd want to push it from the bottom and pull it from the top but not sure how to manage such a thing.
Any clever ideas? Any simple ideas that will make me hit myself in the forehead with a, duh.?
I'd thought about using a long screw in the given holes and trying to mechanically pull up on the floor section but I'd imagine the small M6 thread will just strip.
I'd thought about trying to use a poking rod from underneath and hitting it up but limited access.
Any clever ideas? Any simple ideas that will make me hit myself in the forehead with a, duh.?
I'd thought about using a long screw in the given holes and trying to mechanically pull up on the floor section but I'd imagine the small M6 thread will just strip.
I'd thought about trying to use a poking rod from underneath and hitting it up but limited access.