For Sale AB, Canada: Parts from 1986 HJ60, LHD Canadian spec 24 volt 2H (1 Viewer)

[dwong]

Location

United States

It was a 1986 HJ60, manual, with AC. The engine started right up with two fresh batteries attached and some diesel. The glow indicator light came on/went off as expected. I believe all the start and glow related components were working when I pulled the 2H, but I can't make any promises on functionality.

I've got a bunch of 24 volt parts including most relays, starter, EDIC, wiper motor, AC compressor, alternator with vacuum pump etc. Let me know if you need something and I can see if I have it. I'll likely be selling the 2H or parts off of it also since I was mainly after the H55F.

Just for clarity: All asking prices are in USD plus shipping from Alberta. Anyone local you're welcome to come pick up parts in Calgary!
Update: Paypal from the states is fine, but I'll want to account for the 4% currency exchange fee they charge me.

---

Sold parts update, the parts listed between these lines are gone to new cruiser homes!
- 24V starter
- 24V fuel control relay
- right side mirror
- All AC components, including compressor, brackets, AC amplifier, climate control panel with AC button, evap core/housing
- Drive shafts
- EDIC rod and bolts
- Shifter boots - trans and t-case
- Flasher relay
- Washer fluid reservoir and 24V pump
- 24V blower motor w/fan

---

24V alternator with vacuum pump: $200
Internally regulated, PN 27040-68030

24V wiper motor: $100

24V EDIC motor: $150
I believe the part number is 28571-56150. Can include the rod and the 3 mounting bolts if wanted.

I've got most relays including starter, glow, dimmer, fuel control, wiper control, wiper x2, and the wiring harness: Various prices, message with what you need.

 

[georgebj60]

Interested in the oil pan for the 2H if in good shape. Is the A/C compressor working?

 

[roma042987]

how much for the complete engine and bellhousing

 

[dwong]

Interested in the oil pan for the 2H if in good shape. Is the A/C compressor working?

I honestly don't know if the compressor is working, I test ran the engine when I got the vehicle but that's all. The AC system was empty and I didn't try doing anything with it.

Not quite ready to be parting out the engine yet, as I haven't fully decided that I'm getting rid of it.

how much for the complete engine and bellhousing

As above, not quite ready on selling the engine yet. I'll definitely list it up here when the time comes. Not sure about freight down to the the states unless you've got someone local to pick it up. I know it can be done and people do, but I just haven't dealt with that myself yet. The last thing I want is to make the transaction an ordeal for anyone!

 

[orangefj45]

Do you have a bell housing for an H55F?

 

[dwong]

Do you have a bell housing for an H55F?

I sent you a message

 

[graymudder]

Still have your collection of relays and switches ? Located in New Brunswick

 

[CrusierCobes]

Hi, DM'ed a couple days ago I'm local and need a couple things off your truck.

 

[dwong]

Still have your collection of relays and switches ? Located in New Brunswick

I do still have them. Send me a message with what you need specifically and I can make sure I've got it.

Where in NB are you? I grew up in Bathurst and have some friends and family all over the province still.

 

[dwong]

Hi, DM'ed a couple days ago I'm local and need a couple things off your truck.

Sorry, I hadn't checked in on the forum in a while, answering your message now!

 

[Theodore]

Hello. What would want for the steering box, the extension shaft before the box and the steering linkage?
thanks.
Theodore

 

[dwong]

Hello. What would want for the steering box, the extension shaft before the box and the steering linkage?
thanks.
Theodore

Hi Theodore, of that list I only have the extension shaft, if this part is what you mean:

Are you interested in just that alone without the rest? Send me a message if so, I can check on shipping to Ottawa.

 

[dwong]

I've had a few messages about the AC bracket so I'll put a picture of what I have here:

 

[josepy]

I could use the EDIC push rod and bolts for sure and also both headlight trim pieces. I'm also located in Calgary and will be able to pick up and also see what else you may have left on the vehicle that I need.

 

[dwong]

Update on the AC bracket, I think this is part of it also. Note that the threaded rod for tensioning the pulley is broken off where I'm pointing in the one pic.

 

[dwong]

I could use the EDIC push rod and bolts for sure and also both headlight trim pieces. I'm also located in Calgary and will be able to pick up and also see what else you may have left on the vehicle that I need.

I've got the EDIC rod and bolts. The headlight trim I'm keeping as spared since mine are cracked already. Shoot me a message and we can set it up

 

[Theodore]

Hi Theodore, of that list I only have the extension shaft, if this part is what you mean:

View attachment 2655911

Are you interested in just that alone without the rest? Send me a message if so, I can check on shipping to Ottawa.

Ok thanks anyway. I’ll wait till I can find everything on one truck. Thanks.

 

[CenTXFJ60]

Are you selling any body parts? Looking for mud flaps with flares. Thanks. Jimmy

 

[Knowbuddy]

interested in what shipping would be for the alternator to Bountiful Utah 84010

 

[dwong]

Are you selling any body parts? Looking for mud flaps with flares. Thanks. Jimmy

Hi Jimmy, sorry this one didn't come with mud flaps, and the body was more rust than metal. Destined to be a donor.

interested in what shipping would be for the alternator to Bountiful Utah 84010

I just shipped the AC system including compressor down to Nevada for about $145 USD insured with fedex. I'd expect the alternator would be closer to $70-80 USD.

My lesson learned with the AC system is the 4% paypal fee for currency exchange. I'm so used to free e-transfers. I will be updating that note at the top of my thread to include that.